A good bit of progress this morning on the terrain workbench. The first picture shows the bench top planks in the process of being planed. I just focused on the sides to ensure a tight fit. I'll do the top next week.
Second test fit of the workbench top - all looks to be in good order except the second to last plank from the right - it's warping up in the upper right corner of the picture so I replaced that one with a straighter board.
Attaching the top - the sides are glued together and then screws into place. It's a bit tedious but will be very stable and removable if I damage the worktop and need to replace it.
I'm making very rudimentary drawers to slide under the top and used exceed 2x4's to make a crude guide.
The worktop is attached and level - the board clamped along the top ensure not bending.
Next up on the project list
(1) planing the work surface
(2) Building the drawers and shelves
(3) Attaching the vice (pictured to the left)
(4) Drilling 3/4 inch holes at 6" intervals for the bench dogs
(5) Sanding, sanding, sanding....
(6) Decising on what finish, if any to apply
(7) Cleaning out the garage so the bench can be moved to it's proper place (I'm dreading this step the most!)
2 comments:
Very nice work there Miles!
Very nice work there Miles!
Post a Comment